Tweet
want to install my cc bec on my super and was wondering what the best way to wire it up. should i follow the directions on the package or is there a different better way to wire it in? thanks 
-
Last edited by Rckcrwlr; 02-02-2010, 03:10 PM. -
Re: little help with bec wiring
Here is how you want to do it.
Just ignore where it is showing being plugged into the RX...
Plug the BEC into the BAT slot and you are good to go...Last edited by Rckcrwlr; 06-06-2009, 06:48 AM. -
Re: little help with bec wiring
That's how I did mine. I pulled the red wire from the connector on my ESC & taped it back, and then soldered the wires to my battery. However, the BEC is powered & powering the servo & RX whenever the battery is connected. I'm wondering about installing a 2nd switch inline between the battery & the BEC to be able to power it off, too. What do you guys think on that???
Comment
-
Re: little help with bec wiring
That is what I did...two switches is better than having to unplug one...Originally posted by EvilTwin v2I'm wondering about installing a 2nd switch inline between the battery & the BEC to be able to power it off, too. What do you guys think on that???Comment
-
Re: little help with bec wiring
thanks guys
Comment
-
Re: HOW TO: little help with bec wiring
Here is another diagram...
You can use a regulator or a BEC...Last edited by Rckcrwlr; 06-06-2009, 06:52 AM.Comment
-
Comment