The 2008 mods:
RCP copper alloy ring w/ Stainless pinions front and back
RCP Stainless Axle C's
RC4WD straight axle adapters
VBX bearings throuought
Hitec 5955TG servo
Dig (With rear lock out or free wheel)
Custom made upper link mount front and rear.
Custom made front servo mount (To provide air flow all around servo).
55t Lathe (same)
TR2 ESC (Same)
MSD 2.2" Straight 6 Rock Solid Beadlocks (On the way)
Rock claws and M2K's (tire setup Config. tip thanks to Bender

Biggest difference lower cog and bullet proof internals

Comment