Announcement

Collapse
No announcement yet.

Adding 1/4 scale servos

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Adding 1/4 scale servos

    This tip is something I took from my buddy Heavy an SERCRC member I was able to hangout with again at ECC.

    1/4 scale servos are hosses and about the size of a deck or cards/pack of smokes. To place the servo in as close as you can on a TXT axle you must remove the forward most top cover bolt boss creating a "seat" if you will for the servo. Using 1" wide by 1/8" THK AL bar stock I cut out mounts that were then drilled to mount under the bosses for the lower links and shocks.


    I will put up pics later on tonight of how this is done.

  • #2
    Re: Adding 1/4 scale servos

    Here go on to da pics...



    Comment

    Working...
    X