Announcement

Collapse
No announcement yet.

servo supports

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • servo supports

    anyone have any pics or ideas how to add some strength to the servo mounts on the axle braces. Trying to keep them from moving and shifting.

  • #2
    Re: servo supports

    Originally posted by rockbound
    anyone have any pics or ideas how to add some strength to the servo mounts on the axle braces. Trying to keep them from moving and shifting.
    How are they moving??? Front to back???? Pivoting on the mounting screws???
    sigpic

    Rckcrwlr's Feedback Thread

    Comment


    • #3
      Re: servo supports

      yeah sort of moving front to back and loosening the screws to the axle brace at both ends.

      Comment


      • #4
        Re: servo supports

        Originally posted by rockbound
        yeah sort of moving front to back and loosening the screws to the axle brace at both ends.

        Can you get me a pic, I have a few ideas

        Comment


        • #5
          Re: servo supports

          My Clod does that two...I added the CPE Strengtheners and it seemed to tighten it up...
          sigpic

          Rckcrwlr's Feedback Thread

          Comment


          • #6
            Re: servo supports

            what are those? do you have any pics?

            Comment


            • #7
              Re: servo supports

              Crawford Performance Engineering Axle Stiffeners

              There are inners and outers...get both...
              sigpic

              Rckcrwlr's Feedback Thread

              Comment


              • #8
                Re: servo supports

                O, ok i have the outer ones already, maybe i will try the inner ones as well.

                anyone else have any ideas?

                Comment


                • #9
                  Re: servo supports

                  ok here is what i can uop with for mine. SOLID as a rock NOW!!

                  cut a piece of steel for under the servo and extended arms down to the bolts that hold the two axle case halves together. drilled the holes in the bottom of the plate so the screws could pass through to mount the servo and used a peice of aluminum to pinch the servo to the servo brace and the axle brace. this will also hlep dissapate heat from the servo case.



                  Comment

                  Working...
                  X