as long as you are still running stock outer knuckles this will work for you too.
Firts i got some heavy wall d.o.m. tubing i had lying around my garage which i used for my 1:1 tie rod.
It measures 1 1/4" od and 5/8" id.
i then cut it to 5/8" length

Took a dremel to the inside of the stock outer knuckle to take off the 3 little molded nubs and make a flat surface.

stuck the tubing in the outer knuckle and drilled a hole in the top and bottom.


this pic shows the hole going into the d.o.m. tubing. its slightly smaller than the set screw i will use to anchor them in.

screw the set screw through the knuckle and into the tube.

and put your wheel back on!
that easy, and no one will even know they are in there!!

Comment