traxxas 3 channel

[hazzzy]

Ok I got a reciver prob again I'm not sure why it's doing this again. I did replace the one I had prob's with the last time we were at yorkville but, when I looked at it my dad had put the wires in wrong could this have fried it. Just wondering and let me know.

[Rckcrwlr]

Re: traxxas 3 channel

Ok I got a reciver prob again I'm not sure why it's doing this again. I did replace the one I had prob's with the last time we were at yorkville but, when I looked at it my dad had put the wires in wrong could this have fried it. Just wondering and let me know.

It shouldn't have...what wires were wrong???

[hazzzy]

Re: traxxas 3 channel

I got it working again. I don't kno how I just left the plug out over night pluged them back in. The esc plug was in channel 3, the rear servo was in the reciver pack and, and the front servo was channel 2. Like I said its working again

[Rockbound]

Re: traxxas 3 channel

plugging them in the wrong leads will not effect the reciever at all, it will just make your channels work something different than expected.

my guess is if you still have it mounted on the servo, i would move it.

you should keep all electronic devises as far away from each other as possible, especially the esc and thye receiver.

[hazzzy]

Re: traxxas 3 channel

I kno I have to move it. I did have it on my rear axel and had wire extensions but my brother (razor rc) decided to cut them apart and use them to fix his plugs on the servo and esc that he broke.


I need to get some new ones and move the reciver again.

[hazzzy]

Re: traxxas 3 channel

Well got the rear steer working had to pull all the wires apart and twist back together and this time solider them. Im glad see everyone sun

[Rockbound]

Re: traxxas 3 channel

glad to here you got the rear steer hooked back up!! hope it runs good for you sunday!

[hazzzy]

Re: traxxas 3 channel

yea same here it was working last night and im goin to check it all weekend b4 i leave